Plastic mold processing technology innovation, a variety of new mold materials widely used, mold parts standardization, specialization, forcing us to speed up the design speed, adapt to the development of mold.
The improvement of speed requires the design segment to be completed in about 3 days, and the improvement of the precision of plastic mold requires that the processing methods of each part should be clearly considered in the design process, and the processing methods with high precision and low processing cost should be used as far as possible. The improvement in accuracy and speed is consistent. The improvement of speed must require the improvement of precision, and the improvement of precision will inevitably lead to the improvement of speed.
1. Structural system: template, support column, limit column, etc.
2. Molding system: mother mold core, male mold core, mounting and so on.
3. Pouring system: mainstream channel, branch runner, gate, cold slag well, etc.
4. Guided positioning system: guide column, guide sleeve, zero-degree precision positioning, taper precision positioning and so on.
5. Top-out system: top needle, cylinder needle, push plate, gas top, thread top-out, composite top-out and so on.
6. Temperature control system: water channels, water towers, sprinklers and so on.
7. Exhaust system: parting surface exhaust, block exhaust, counter-needle exhaust, exhaust steel, etc.
8. Core pumping system: front mold pumping core, rear pumping core, sloped top, etc.
9. Standard parts system: screws, casings, waterproof rings and so on.
10. Safety reset system: micro-switch, forced reset, etc.
The improvement of speed requires the design segment to be completed in about 3 days, and the improvement of the precision of plastic mold requires that the processing methods of each part should be clearly considered in the design process, and the processing methods with high precision and low processing cost should be used as far as possible. The improvement in accuracy and speed is consistent. The improvement of speed must require the improvement of precision, and the improvement of precision will inevitably lead to the improvement of speed.
1. Structural system: template, support column, limit column, etc.
2. Molding system: mother mold core, male mold core, mounting and so on.
3. Pouring system: mainstream channel, branch runner, gate, cold slag well, etc.
4. Guided positioning system: guide column, guide sleeve, zero-degree precision positioning, taper precision positioning and so on.
5. Top-out system: top needle, cylinder needle, push plate, gas top, thread top-out, composite top-out and so on.
6. Temperature control system: water channels, water towers, sprinklers and so on.
7. Exhaust system: parting surface exhaust, block exhaust, counter-needle exhaust, exhaust steel, etc.
8. Core pumping system: front mold pumping core, rear pumping core, sloped top, etc.
9. Standard parts system: screws, casings, waterproof rings and so on.
10. Safety reset system: micro-switch, forced reset, etc.